A child has an accident in the hotel pool at 2pm on a Saturday. What the staff member who sees it does next matters more than most properties plan for.

Without a written plan, the response is usually a guess: scoop out what is visible and carry on. The problem is that the parasite most often behind pool outbreaks does not die at normal pool chlorine levels.

CDC’s Model Aquatic Health Code page reports over 200 disease outbreaks linked to pools, hot tubs and splash pads during 2015 to 2019. The leading cause was Cryptosporidium, which CDC describes as very chlorine tolerant and able to sicken hundreds or even thousands of people.

This post sets out the response the MAHC 5th edition describes, so a hotel, condo or club can turn it into a laminated card and a trained team. The MAHC is guidance. It becomes law only where a jurisdiction adopts it, so confirm what your local code says, and ask your health department if it has its own procedure.

What the code expects before an incident

The MAHC says every aquatic facility shall have a contamination response plan, within its emergency action plan, covering formed-stool, diarrheal-stool, vomit and blood contamination. The plan must include:

  • procedures for response and cleanup,
  • provisions for training staff, and
  • a list of equipment and supplies for cleanup.

The code goes further on people and checks:

  • At least one person on site while the facility is open must be trained in the response procedures and in PPE and the OSHA Bloodborne Pathogens Standard, 29 CFR 1910.1030.
  • Staff must be told of any updates to the plan.
  • Supplies are verified at least weekly by the qualified operator.
  • The plan is reviewed at least annually.
  • It is kept on site and available for the health authority to see.

The daily pre-opening inspection also includes confirming that the response plan, materials and equipment are available.

Step 1: close the pool

The qualified operator closes the venue to swimmers immediately, until the remediation is complete. The closure covers the affected venue and any other venues that share the same recirculation system. At a hotel, that can mean the kiddie pool and the main pool close together.

Step 2: remove the contamination safely

Contaminating material is removed with a net, scoop or bucket and disposed of in a sanitary manner. The net or bucket is cleaned and then disinfected, for example by leaving it in the pool during the disinfection period. The MAHC says that aquatic vacuum cleaners must not be used to remove contamination unless the waste goes to a sanitary sewer and the equipment can be disinfected.

Step 3: set the water up for disinfection

Before raising chlorine, the operator should:

  1. check that pH is 7.5 or lower and adjust if needed,
  2. confirm water temperature is 77°F (25°C) or higher,
  3. keep the filtration and recirculation running while chlorine is raised,
  4. test free chlorine at several points to confirm the level throughout the pool for the whole disinfection time, and
  5. use only non-stabilized chlorine to raise the level.

Chlorine works better at lower pH, and the MAHC reminds operators that stabilized chlorine slows inactivation. Pools that contain cyanuric acid need longer times, as below.

Step 4: raise chlorine for the right time

The required level and time depend on the type of contamination. All levels refer to free chlorine measured by the DPD method, and the timer starts when the pool reaches the target level.

IncidentFree chlorineHold for
Formed stool2.0 ppmAt least 25 minutes
Vomit2.0 ppmAt least 25 minutes
Diarrheal stool20 ppmAt least 12.75 hours (CT value 15,300 mg-min/L), or use secondary treatment

Where the water contains cyanuric acid or stabilized chlorine, formed stool and vomit contact times are doubled. For diarrheal stool, the MAHC route for pools with stabilizer is to hyperchlorinate after first lowering cyanuric acid to 15 ppm or less by draining and refilling if needed, then holding 20, 30 or 40 ppm for the times in its table (for example 28, 18 or 8.5 hours at 15 ppm cyanuric acid). The other options are secondary treatment that reduces Cryptosporidium, or draining the pool completely.

For a brominated pool, add chlorine to reach the same levels for the same time, then adjust the bromine residual before reopening.

The MAHC treats blood differently. It states that blood contamination of a properly maintained pool’s water does not pose a public health risk to swimmers. Operators may still choose to close and treat it like formed stool to reassure patrons.

Step 5: reopen only after the levels are verified

The pool reopens when the contact time has been met at the required level, with tested readings recorded. If your time and level do not match the table, do not guess: either hold longer or ask your health department.

Step 6: record the incident

The MAHC requires a record for events involving death, CPR or AED use, medical transport, or a diagnosed recreational water illness, with the health authority notified within 24 hours. A contamination event is not on that list on its own, but treat it as one: record it the same way. A record should include:

  • date and time,
  • venue and which venues were closed,
  • what happened and the type of contamination,
  • who responded,
  • free chlorine, pH and temperature readings and their times,
  • the contact time held, and when it started,
  • who authorised reopening, and when.

Keep the record with the other operation records for at least 3 years, or longer if your local code says so.

Who does what

The pool operator or a trained maintenance person runs the chemistry. Housekeeping and cleaning contractors usually handle the deck, locker rooms and showers, and a contamination on the deck or in a changing room needs its own disinfection routine and PPE. If cleaners will respond to contamination, put it in the contract and train them. The same bloodborne pathogen training the MAHC mentions applies to any employee who may meet bodily fluids at work.

Prevention you can do every day

Bather hygiene is the part of this you can influence every day. The MAHC requires signage at the exit of the hygiene facility used to reach the pool, with messages including do not swim when ill with diarrhea, shower before entering the water, check your child’s swim diaper regularly, diaper changing on the deck is prohibited, and wash hands before returning to the pool. Daily checks should confirm those signs are in place, showers and toilets are working and stocked, and the diaper-changing station is clean.

How TidyTrack fits in

A QR poster by the pool can hold the response card and the incident checklist. When the event happens, the person on duty scans it, steps through the closure, readings and contact time, and logs each one with a timestamp and a name. A weekly checklist item can prompt the operator to verify that the response kit is stocked. TidyTrack records the response. It does not replace training, the response plan or your health department’s guidance. Related reading: why 1 in 8 pool inspections ends in a closure, the pool and spa water testing log and hotel hot tubs and Legionella.