Hot tubs are the part of a hotel pool area that most needs a written routine. The water is warm, the surfaces grow biofilm, the jets turn water into a fine mist, and the disinfectant is used up quickly by bathers. That combination is what Legionella bacteria need.
CDC’s guidance for hotels is direct about it. Legionnaires’ disease is deadly for approximately 1 in 10 people who get it, and outbreaks at hotels and resorts can interrupt services and carry considerable financial and reputational costs. The same page says the problems that lead to Legionnaires’ disease are preventable through a water management program.
This post summarises that CDC guidance for operators of hotel and facility hot tubs.
Where Legionella grows in a hotel
CDC names several places in a hotel where Legionella can grow and spread in droplets small enough to inhale. It grows best in warm water that is not moving or that has too little disinfectant.
- Hot tubs: warm temperatures support growth, and bacteria can spread through the jets if the tub is not well maintained with continuous disinfectant.
- Showers: showerheads can grow and spread Legionella when disinfectant is low or hot water is not stored at an appropriate temperature.
- Unoccupied floors or rooms: low occupancy reduces water flow, which can lower disinfectant levels and hot water temperature.
- Cooling towers, decorative fountains and water supply interruptions, such as nearby construction.
The low-occupancy point matters for any seasonal property or a hotel with a quiet winter. A tub that is topped up but barely used can sit at the wrong temperature with little disinfectant left.
Why hot tubs need extra care
CDC’s hot tub module explains that hot tubs maintain water temperatures within the most favorable range for Legionella growth, 77 to 113°F (25 to 45°C), create aerosols and accelerate the decay of disinfectants. The four factors that drive growth are sediment and biofilm, temperature, water age and disinfectant residual.
Because the temperature range cannot be avoided, the other three have to be controlled. CDC adds that water should not exceed 104°F (40°C) to prevent scalding.
Start with a water management program
CDC describes a water management program (WMP) as a multi-step, continuous process designed to identify areas in a building where Legionella could grow and spread, reduce the risk by managing and monitoring the water system, and trigger action when risks are identified. CDC’s hotel page states that WMPs are now an industry standard for most hotels and tourist accommodations in the United States and offers a free toolkit. It suggests assembling a team with the right mix of skills, which in a hotel usually means engineering, housekeeping, pool maintenance and management.
The hot tub module asks operators to use the WMP to establish, track and improve operation and maintenance activities for each tub.
The operating limits for hot tubs
CDC’s hot tub guidance lists these practical controls:
- Follow your local code. Where there is none, use CDC’s Model Aquatic Health Code.
- Disinfectant and pH: free chlorine of 3 to 10 ppm or bromine of 4 to 8 ppm, with pH between 7.2 and 7.8.
- Test disinfectant residual and pH at least twice per day, as often as hourly in heavy use.
- Keep water flowing across the filter 24 hours a day.
- Follow the manufacturer’s instructions for backwashing sand and diatomaceous earth filters and replacing cartridge filters.
- Post the maximum bather load and rules for use. CDC notes the MAHC recommends 10 square feet per bather.
- Use automatic feed and control systems for disinfectant and pH in public hot tubs.
- Disinfect daily: remove the tub from service and run a higher-than-normal residual for one to four hours. CDC gives a free residual of 10 mg/L, or 10 times the combined chlorine level, whichever is greater, as a common example.
- Drain, scrub, clean and refill the tub regularly, and scrub all surfaces each time it is drained.
- Train all staff who operate or maintain it.
- Keep complete operating records and review them for trends in residual, pH and maintenance.
- Post signage warning that the tub carries higher health risks for people who are immune compromised or who have chronic lung disease.
The MAHC adds that spa free chlorine should be at least 3.0 ppm, bromine at least 4.0 ppm, and that the maximum temperature is 104°F. Its spa signs also say that children under 5 and people using alcohol or drugs that cause drowsiness should not use spas.
Water age: when to replace the water
CDC gives a formula for replacing hot tub water based on use: the water replacement frequency in days is the spa volume in gallons divided by 3, divided by the average number of users per day.
For example, a 600 gallon tub with an average of 10 users a day comes to (600 / 3) / 10, which is 20 days. A tub with 40 users a day comes to 5 days. Put the calculated interval on the maintenance schedule and record each drain and refill.
Display tubs and idle tubs
CDC notes that if a hot tub on display holds water, it also requires disinfectant. A tub that is closed for the season or unused during a quiet week needs a decision: drain it and keep it dry, or keep it running and testing. Water left sitting without disinfectant is the problem.
If Legionella is found or illness is suspected
CDC says any detection of viable Legionella in a hot tub should prompt a response, including a review of the WMP and corrective actions. Where there is no illness but control has lapsed, CDC’s remediation steps are to remove the tub from service, hold 10 ppm free chlorine for 1 hour, drain, scrub and rinse all surfaces, service filters, refill and return to the normal residual once performance indicators are within control limits.
If the local health authority suspects an outbreak or illness, the process is stricter. It includes sampling with public health, scrubbing with water at a minimum of 5 ppm free chlorine, replacing filter media, and hyperchlorinating to 20 ppm for 10 hours with the jets off for the first hour, then on for nine. Resume service only in coordination with the public health authority. The MAHC is similar. It tells the operator to close the spa to bathers immediately, switch off the jets and pumps without draining, and contact the local health authority about laboratory testing, and it says the spa should not be reopened until all test results are negative for Legionella. Do not run this procedure on your own for a suspected outbreak. Call the health department first.
Records that show the program is running
A water management program is only as credible as its records. For each hot tub, keep:
- Each test: time, free chlorine or bromine, pH, temperature and the person who tested.
- Each daily disinfection: residual reached, how long, who did it.
- Each drain, scrub and refill, with the calculated water age interval beside it.
- Filter work: backwash and cartridge changes.
- Any out-of-range reading and what was done.
- Staff training: who is trained, and when.
- Any Legionella test results and the response.
The MAHC suggests keeping operations records for at least 3 years. Check your local code for the period it requires.
How TidyTrack fits in
TidyTrack suits the routine part of this: a QR poster at the hot tub, a checklist for the twice-daily test, numeric readings with an acceptable range, and an issue raised when a reading is out of range. Schedules flag a missed test, and every entry carries the time, area and the person who logged it. It does not replace a controller, test kits, a qualified operator or a proper water management program, and it is not Legionella testing. For the wider daily check, read why 1 in 8 pool inspections ends in a closure. For hotels, see the hotel industry page.